To Next PageTo Next Page
Need help?Do you have a question about the ITT HYDROVAR Series and is the answer not in the manual?
General| Category | Control Unit |
|---|---|
| Brand | ITT |
| Series | HYDROVAR |
| Protection Class | IP55 |
| Frequency | 50/60 Hz |
| Output Current | Depends on model |
| Relative Humidity | Up to 95% (non-condensing) |
| Altitude | Up to 1000m |
Safety warnings about suspended loads and securing the unit against tipping.
Explanation of various operating modes for the HYDROVAR.
Details on the Actuator mode, used with external speed signals or digital inputs.
Mode selection for single HYDROVAR pump operation without RS485 connection.
Configuration for multi-pump systems with one Master Inverter controlling slave pumps via relays.
Mode for multi-pump systems using RS485 communication between HYDROVAR units.
EMC requirements for different environments and compliance standards for the HYDROVAR.
Step-by-step guide for assembling the HYDROVAR unit onto a motor.
Information on protective measures like earthing, RCDs, and circuit breakers for electrical safety.
Guidelines for ensuring electromagnetic compatibility through proper cable installation.
Overview of wiring and connection points on the HYDROVAR Master/Single Inverter.
Details on connecting the main power supply terminals for single and three-phase connections.
Instructions for mounting the PTC and connecting motor cables (star/delta).
Description of the Power Unit's control terminal blocks and connections for basic inverter operation.
Configuration for solo run operation of Basic Inverters or as a soft-starter.
