4. ELECTRICAL CONNECTION
• The positioning of the device must ensure that the power connection is not damaged or
pinched.
• Do not install multiple portable power outlet strips or other portable power supplies in back
of the device.
•
The machine is supplied with a 1.5 m (4.92 feet) cable of length. In case the supply cable
is damaged, it should be replaced by a cable of special assembly to be furnished by the
manufacturer or post-sale service. Such replacement should be performed by qualified
technical service only.
The machine should be places in such a way as to allow a minimum space between the
back and the wall to allow an easy access and without risks to the cable jack.
Safeguard the base of the jack.
It is advisable to install a power switch and the appropriate electrical safety devices in
accordance with local and/or national regulations in each case.
Voltage and tension are indicated in the nameplate and on the technical
specifications of this manual. Variation on voltage above the 10% stated on the
nameplate could result on damages or prevent the machine start-up.
IT IS MANDATORY TO GROUND THE EQUIPMENT
To avoid possible discharges on individuals or damages to the equipment, the
machine should be grounded pursuant local and/or national regulations as the
case may be.
THE MANUFACTURER SHALL BE HELD HARMLESS IN CASE OF DAMAGES
ARISING DUE TO THE LACK OF THE GROUND INSTALLATION.
To Next Page
Loading...
