DIGISPENSE 3009 CONTROLLER MODULE, STYLE B Page 3-52
29 October, 2019 IVEK Corp. P03R017E
Setup B Screen Description - The Setup B screen displays the lOGIC I/O settings and allows a user with Supervisor
permission to change the parameters. The current permission level determines which push-buttons are available as
shown.
Status - The status indicates the operational state of the system. Refer to section 3.3.8 for an explanation of each
status type.
Aux Out 1 & 2 - Aux Out 1 & 2 setting selects the signal type (in bold) and condition for an additional output signal.
The output signal can either be DISABLED or provide information about the system as shown below.
Outputs 1 - 4 - Outputs 1 – 4 setting selects the signal type (in bold) and condition for an additional output signal.
The output signal can either be DISABLED or provide information about the system as shown below.
Input CC 1 & 2 - The Input CC 1 & 2 setting selects the signal type (in bold) and condition for an additional input
signal. The input signal can either be DISABLED or provide information about the system as shown below.
Inputs 1 - 4 - Inputs 1 – 4 setting selects the signal type (in bold) and condition for an additional input signal. The
input signal can either be DISABLED or provide information about the system as shown below.
To change a value;
1. Press the Arrow push-buttons to highlight the parameter.
2. Press the Enter push-button to bring up either the Select New Value or Enter New Value screen.
3. In the Select New Value screen use the up and down arrow push-buttons to select the value. In the Enter New
Value screen press the Minimum or Maximum push-buttons to select the desired value or use the left and right
arrow push-buttons to select the digit and the up and down arrow push-buttons to change the digit's value.
4. Press the Enter push-button.
To Next Page
Loading...