DIGISPENSE 3009 CONTROLLER MODULE, STYLE B Page 3-94
29 October, 2019 IVEK Corp. P03R017E
h23 h23,<value2> Returns the output 3 setting.
h23,<value2> h23,<value2> Sets the output 3 configuration.
<value2>
Same as h20, default = <BUSY> Discharge
h24 h24,<value2> Returns the Output 4 setting.
h24,<value2> h24,<value2> Sets the Output 4 configuration.
<value2>
Same as h20, default = <STATUS> Reference
h29 h29,<value2> Returns the Aux Out 2 setting.
h29,<value2> h29,<value2> Sets the Aux Out 2 configuration.
<value2>
Same as h20, default = <DISABLED>
h40 h40,<value2> Returns the Aux Out 1 True setting.
h40,<value2> h40,<value2> Sets the configuration.
<value2>
0 = Conducting (default)
1 = Not Conducting
h41 h41,<value2> Returns the Output 1 setting.
h41,<value2> h41,<value2> Sets the Output 1 configuration.
<value2>
0 = Conducting (default)
1 = Not Conducting
h42 h42,<value2> Returns the Output 2 setting.
h42,<value2> h42,<value2> Sets the Output 2 configuration.
<value2>
0 = Conducting
1 = Not Conducting (default)
h43 h43,<value2> Returns the Output 3 setting.
h43,<value2> h43,<value2> Sets the Output 3 configuration.
<value2>
0 = Conducting (default)
1 = Not Conducting
h44 h44,<value2> Returns the Output 4 setting.
h44,<value2> h44,<value2> Sets the Output 4 configuration.
<value2>
0 = Conducting (default)
1 = Not Conducting
h49 h49,<value2> Returns the Aux Out 2 setting.
h49,<value2> h49,<value2> Sets the Aux Out 2 configuration.
<value2>
0 = Conducting (default)
1 = Not Conducting
k => KEYLOCK
k or k0 k0,<value2> Returns the current Enable Motion setting.
k0,<value2> k0,<value2> Sets the Enable Motion configuration.
<value2>
0 = Disable
1 = Enable (default)
k1 k1,<value2> Returns the current Front Panel Lock setting.
k1,<value2> k1,<value2> Sets the Lock Front panel configuration.
<value2>
0 = Enable All - Front Panel (default)
1 = Disable Recipe Save
2 = Disable Recipe Save & Value Change - Front Panel
3 = Disable Recipe Save, Value Change & Prime Direction - Front Panel
4 = Disable Recipe Save, Value Change & Recipe Get - Front Panel
5 = Disable Recipe Save, Value Change, Recipe Get & Prime Direction – Front Panel
To Next Page
Loading...