Alarm
6 720 643 415 (2010/03)
33
11.8.5 Screed drying set point value for heating not
reached
Function: Activated when the set point value for a drying
step has not been reached.
Reset condition: The warning is deactivated on
acknowledgement of the warning display.
Category: L.
Alarm lamp: Yes.
Restart: The warning does not shut down anything, the
drying program continues with the following step.
B Contact the dealer in the event of warning being
repeated.
11.8.6 Check connection to I/O board x
Function: Depends on the board.
Reset condition: Communication with the board is re-
established.
Category: M.
Alarm lamp/buzzer: No.
Restart: Acknowledgement is required.
B Contact the dealer.
To Next Page
Loading...
