31
for VIVI PID and ALEX PID model)
In addition to numeric values, the display
shows a blinking LED that indicates that
the resistance is operating.
To turn off the heating elements
press the button for about 2
seconds and the display oFF.
To activate the resistance of the coffee
boiler, just press the button For set
point programming the press the button
when the display shows PrG press the
button .
Select by pressing and , the desired temperature, a minimum of 121°C for a maximum
of 128°C. After 3 seconds the display shows the selected temperature.
Adjusting Parameters
With machine off hold down the and simultaneously and turn on the machine.
When the display shows F.03 release the keys.
The button to scroll the parameters while the button enters the programming menu.
Power cycle the machine to confirm and exit programming.
Parameters default
Parameter Display Data set
F.03
°F 250-262.4 (not beyond)
°C 123 (1,2bar)
P. X.X 3
l. X.XX 0.05
d. XX.X 2
F.04 X 0 (no change)
Preset parameters
To machine off, press the button and turn the machine.
When the display shows the PrS, release the button and shut down and restart the machine.
Reset all values to the table above, for the desired temperature refer to the diagram ”temperature
range”
To Next Page
