EasyManua.ls Logo

izzy CM6823 - To Make Espresso

izzy CM6823
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
in the tank. Water level should not exceed the “MAX” mark in the tank. Then place the tank
into the appliance properly.
2. Select the one-cup or two-cup mesh, set stainless steel mesh into metal funnel, pull the
press bar backward, make sure the tube on the funnel aligns with groove in the appliance,
then insert the funnel into the appliance from the “Insert” position and release the press bar
and you can fix them into coffee maker firmly through turning it anticlockwise until it is at the “”
lock” position. (See Fig. 1)
3. Put a jug under the steam/hot water nozzle.
4. Fit the desired filter into the filter holder (without coffee) and attached to the machine by
positioning it under the boiler outlet and turning to the right, ensure it is firmly located.
5. Position 2 cups under the filter holder, if you use the same cup that the coffee will be served
in it will be preheated. Alternatively the cups can be preheated on the cups warming tray.
6. Connect the appliance to power supply source. Make sure the steam control knob is on the
“OFF” position, which means it is closed.
7. When the blue lamp is stabilized and illuminated, you should press the coffee/hot water
selector again, there will be hot water flowing out. The pre-heating is finished.
To Make Espresso
• Preheat the appliance as above ‘Preheating the espresso machine’.
• Check that there is water in the tank.
• Select the desired filter and fit into the filter holder.
• Use the smaller filter for making one cup of coffee and the larger filter for 2 cups.
Add the coffee using the measuring spoon provided one full spoon per cup, level the surface
then lightly press with the tamper of the measuring spoon, wipe off any coffee around the rim.
• Note: When buying ground coffee make sure it is suitable for espresso machines.
• Note: Never press the coffee too firmly as the coffee will come out slowly and the cream will
be of a dark colour, however, if it is pressed too lightly, the coffee will come out too fast and the
cream will be a light colour.
Attach the filter holder into the boiler outlet, turn it to the right to lock into position.
• Put one or two cups underneath, if making one cup of coffee, centre your cup in the middle.
• Ensure the On/Off switch (1, schedule 1) is pressed down then the power

Related product manuals