21
Note: In choosing the size of the jug, it is recommened that the diameter is not less than
75mm and bear in mind that the milk increases in volume by 2 times, make sure that the
height of jug is enough.
Caution: Never turn the steam control button rapidly, as the steam will accumulate
rapidly in short time which may increase the potential of the risk of explosion.
• Position the jug under the froth device (11, schedule 1).
• Place the froth device into the milk about 2cm deep and turn the steam control knob (6,
schedule 1) in an anti clockwise direction, the milk will begin to increase in volume and appear
frothy. Froth milk in the way moving vessel from up to down. Once the desired temperature is
reached, stop the steam by turning the steam control knob rightwise.
Note: When operation in steam mode and with the steam control knob turned off, some water
may drop from the boiler outlet or the attached filter holder. This water collects in the drip tray
(4, schedule 1). Alternatively you can place a cup under the boiler outlet or the attached filter
holder.
• Pour the frothed milk into the cups containing the espresso coffee.
• Clean steam outlet with wet sponge immediately after steam stops generating, but care not
to hurt!
• Press the “On/Off for Coffee” (1, schedule 1) switch to cut the power source off.
Important:
• Never operate the froth device for longer than 2 minutes at one time.
• Never allow the milk to boil as this will spoil the flavor of the coffee.
• To prepare more than one cup of cappuccino, first make all the espresso coffees, then at the
end prepare the frothed milk for all the cappuccino.
• Pour the frothed milk into the espresso prepared; now the cappuccino is ready. Sweeten to
taste and if desired, sprinkle the froth with a little cocoa powder.
• Press the steam switch to cut the power source off.
• We recommend that you allow the maker to cool down at least for 5min before making coffee
again. Otherwise burnt odor may occur in your espresso coffee.
Cleaning and Maintenance
• Always unplug the machine and make sure that it has cooled down before you clean it.
• Don’t wash parts in the dishwasher.
• Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip
tray and removable shelf regularly then dry them.
Note: Do not clean with alcohol, or solvent cleanser. Never immerse the housing in water for
cleaning. Never immerse the cord, plug, or appliance itself in water or other liquids.
Water tank/Metal Funnel
Wash the water tank and the metal funnel with water and dish-soap, rinse well and let dry.
Stainless steel mesh (coffee filter)
1. Wash and dry well after every use.
2. After approximately every 100 uses dismantle and clean more thoroughly as follows:
Remove the metal filter from the filter holder. Clean the filter in hot water using a brush, make
sure the holes in the filter are not blocked, if necessary clean with a pin. Dry the parts then
reassemble, make sure the parts are correctly assembled.
Froth device/Hot water nozzle
• Prior to cleaning allow some hot water to flow out of the nozzle then unplug and allow to cool
before proceeding.
To Next Page
Loading...
