J.P. Instruments EDM-700

Pilot’s Guide
Engine Data Management
EDM-700
EDM-800
Copyright  2001 J.P. Instruments, Inc.
All Rights Reserved
J.P. INSTRUMENTS INC.
Information: P. O. Box 7033
Huntington Beach, CA 92646
Factory: 3185 B Airway
Costa Mesa, CA 92626
(714) 557-5434 Fax (714) 557-9840
www.jpinstruments.com
Printed in the United States of America Rev P 05/2001

J.P. Instruments EDM-700 Specifications

General

Manufacturer	J.P. Instruments
Model	EDM-700
Display	LCD
Operating Temperature	-20°C to 70°C
Weight	1.5 lbs
Power Supply	10-30 VDC

Summary

Section 1 - Introduction

Engine Data Management System

Explains the EDM system's advanced monitoring and diagnostic capabilities.

Section 3 - Operating Procedures

Diagnostic Testing and Procedures

Covers startup tests, modes, leaning methods, and flight phase operations.

LeanFind Mode Details

Provides step-by-step instructions and explanations for the LeanFind procedure.

Section 4 - Diagnosing Engine Problems

Typical Normal Parameters

Operation by Flight Phase

Troubleshooting Engine Issues

Covers misapplications, alarms, pre-ignition, detonation, and common problems.

Section 7 - Long Term Data Memory

Data Capture and Transfer to PC

Section 8 - Personalizing

Pilot Programming and Calibration

Covers HP constant adjustment, MAP calibration, and TIT probe setup.

Section 9 - Programming the EDM-800 Horsepower Constant

Horsepower Constant Adjustment

Guides on setting the HP constant for accurate %HP display based on aircraft specs.

Section 10 - Programming Manifold Pressure (MAP)

MAP Calibration Procedure

Section 11 - Programming Use of Factory Original TIT Probe

TIT Probe Calibration

Section 12 - Programming the Fuel Flow Option

Fuel Flow Parameters Setup

Covers K Factor, Accumulate, and GPS format settings for fuel flow.

Fine Tuning the K Factor

Provides a procedure to adjust the K factor for accurate fuel consumption calculations.

Section 13 - Programming Long Term Data Memory

Data Recording Settings

Section 14 - Alarm Limits

Default and Custom Alarm Limits

Lists factory default limits and how to change them for various parameters.