8
Step 7 Installation of radio
▼ 1. Glue the factory ready-made servo tray in position.
▼ 2. Fit the throttle and elevator servo as shown.
▼ 3. Connect one end of the throttle control cable to the engine throttle arm, the other end to the
throttle servo arm. (See Figure 10.)
▼ 4. Install the battery.
▼ 5. Install the receiver.
Figure 10. Radio installation
REMARKS
The battery charging lead can be mounted on the outside of the fuselage using any number of readily
available mounts. This will assist charging and battery monitoring without the need to remove the wing.
The On/Off switch can be mounded on the side of the fuselage or as shown using some pull/pull wire
running through each side of the fuselage.
The battery position may need to be moved to obtain the correct C/G. This can depend on which motor is
used or the weight of RX battery pack being used.
To Next Page
Loading...
