J5create Display Adapter - Page 13

USB DISPLAY ADAPTER USER MANUAL
13
A. Connect all external display devices (monitor/ projector) to the
VGA/DVI connector of USB 3.0 Display Adapters and switch power on.
B. Connect the USB 3.0 Display Adapter into an available USB port of a
PC or Notebook.
After Inserting an USB 3.0 Display Adapter into a USB port, the systems
will automatically start the installation procedure and the prompt
message will pop-up on the task bar.
The Device driver software was installed properly,
if you are going to install more USB 3.0 Display Adapters, repeat step A& B
or restart computer.
The functions of the USB 3.0 Display Adapter will be activated after the
computer restarted. You might see the extend display shown on the
display device.