Jabra Engage 65 Mono
How do I use my Jabra Engage 65/75 wireless headset as a
corded USB audio device?
Prerequisites
Firmware version 2.0.5
Jabra Direct - latest version
To use your Jabra Engage 65/75 wireless headset as a wired USB audio
device, use one of the following options:
Option 1
1. Insert the USB cable into a USB port on the computer.
2. Press and hold the volume up (+), volume down (-), or Mute button.
3. Insert the USB cable into the headset.
4. The headset LED will flash green. When it stops flashing, release the
button. You can now select the Jabra Engage 65/75 as an audio
device on the computer.
Option 2
1. Insert the USB cable into the headset.
2. Put the headset on.
3. Press and hold the volume up (+), volume down (-), or Mute button.
4. Insert the USB cable into a USB port on the computer.
5. When you hear the power-on tone in the headset, release the button.
You can now select the Jabra Engage 65/75 as an audio device on the
computer.
The headset will return to DECT mode after 5 seconds if the USB wired
mode is not established.
To change your headset back to a wireless connection, disconnect the USB
To Next Page
Need help?
General
Weight and Dimensions
