UK
installatiOn and setUp
1. Assemble the headset into a wearing style by doing
one of following:
- If you will use the headband, then press the
headset into the headband as shown below. Once
assembled, you can rotate the headset for use on
either ear.
- If you will use the ear hook, then press the pin of
the ear-hook attachment down into the hinge as
shown below. To wear on your left hear, pres the
pin into the opposite end of the hinge.
2. Connect the power supply to the power port [14]
(marked with
) on the base and then plug it
into a wall outlet.
3. A setup wizard automatically launches on the
touchscreen [9]. Follow the on-screen instructions
to assemble and configure your headset solution.
Make selections by touching the screen icons
to progress through the wizard. Completing the
wizard will take about 10 minutes.
3 sec.
4. Insert the CD-ROM included with your headset
into your PC and run the setup program there. This
will install utility software and drivers for working
with your headset and will also install the full user
manual for the solution (in PDF format).
If you have any questions as your work through the
setup wizard, or if you would like more information
about how to use the many advanced features of
your headset solution, please refer to the user manual
installed on your PC.
To Next Page
Loading...
Need help?
General
