Jabra TALK - Turning Your Headset On and Off; Pairing It With Your Phone; Put the headset in pairing mode; Set your Bluetooth phone to ‘discover the TALK

5
ENGLISH
JABRA TALK
TURNING YOUR HEADSET ON AND OFF
- Slide the on/off button towards the symbol “I” to turn the
headset ON. When you do so both indicators will ash on the
Jabra StatusDisplay™.
- Slide the on/o button towards the symbol “O” to turn the
headset o.
PAIRING IT WITH YOUR PHONE
Headsets are connected to phones using a procedure called
‘pairing’. By following a few simple steps, a phone can be paired
with a headset in a matter of minutes.
1 Put the headset in pairing mode
- When you turn on your Jabra TALK for the rst time, the
headset will automatically start up in pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the Bluetooth® status indication on the StatusDisplay™ is
ashing.
2 Set your Bluetooth® phone to ‘discover’ the TALK
- Follow your phone’s instruction guide. First make sure that
Bluetooth® is activated on your mobile phone. Then set your
phone to discover new devices. This usually involves going
to a ‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a Bluetooth® device.*
3 Your phone will nd the Jabra TALK
- Your phone will nd the headset under name “Jabra TALK”.
Your phone then asks if you want to pair with the headset.
Accept by pressing ‘Yes’ or ‘OK’ on the phone. You may be
asked to confirm with a passkey or PIN. Then use 0000
(4 zeros). Your phone will conrm when pairing is complete
and the Bluetooth® status indication on the StatusDisplay™ will
shift from ashing light to steady light and the headset voice
guidance will say “connected”.
* Phone dependent