English
Tip: Have a qualified individual check blade tension after the first few days of operation.
Capacity: Number of loaves sliced per day: 6,000 (depending on the type of bread).
Loaf size:
(MJL – MJL ETL – MJF – MJG – MJG ETL – MJM - MJC – MJC ETL) (L x W x H) (cm): min.: 12 x 6
x 6 - max.: 44 x 31 x 16
(MJF - MJG – MJG ETL – MJC – MJC ETL) (L x W x H) (cm): min.: 12 x 6 x 6 - max.: 44 x 26 x 16
8 MAINTENANCE
8.1 Daily, by a trained operator.
A. Check whether you need to empty the crumb tray.
B. Clean the tables using a brush.
C. Use a dry cloth to clean the inside.
D. Use a damp cloth to clean the outside.
8.2 Every 25,000 loaves and/or at least once a year, by an approved agent.
Remove the plug from the socket.
Check the condition of the cutting blades.
If you notice a deterioration in cutting quality, the cutting blades must be replaced (JAC part number:
610001, 610011 in the JAC Spare Parts catalogue).
If the blades need to be replaced, do so in accordance with the blade replacement procedure.
NB: Do not overtighten the blades, as this risks distorting the frames.
Sweep and vacuum the inside of the machine.
Check bearing condition, then lubricate them.
Lubricate the actuator joints.
Check that your approved agent has recorded his work in your service booklet in order to maintain
your 5-year warranty cover.
Additional maintenance for models with lubrication
The oil to be used is: 7940019 (as quoted in the JAC “spare parts” catalogue).
Or a food-grade liquid vegetable oil with a natural antioxidant.
Every 1,000 loaves or every 15 days, by a trained operator:
Add the dose of food-grade oil (100 to 150 ml) required to impregnate the felt pads on the loaf pusher
(operate the carriage advance button to enable access to the oil filler plug).
Every 25,000 loaves and/or at least once a year, by an approved agent:
Remove the plug from the socket.
Replace the pusher felt pads.
8.3 Blade replacement.
(fig.6,7,8)
Always wear cut-resistant gloves (EN 388:2003 version B= 5) and safety footwear when replacing the
blade or when working in the vicinity of the blade.
Ensure that the plug on your machine has been disconnected from the mains.
To Next Page
Loading...
Need help?
General
