Jack A Series - Technical Parameters - P62-PA1; Machine Mode Parameters P62-PA1

CONFIDENTIAL PROJECT NAME | date 项目名称 | 日期 22
Operation Instruction –technical parameter
P 6 2 0/1/2/3 0
Special mode:
0: normal Mode
1: simply sewing mode
2: motor initial angle measurement
3:
Calculate the transmission ratio mode
4: automatic test
modle 1 (It has needle stop position of automatic test, running 5s , stopping
3S)
P 6 6 0/2 2
2
：open safety switch function；0: close；
P 6 8 0~5000 4000
The maximum speed limit of the machine head
（inside spped limite）
P 7 1 0~50 2
Slow release lifter level adjustment, the smaller values and the faster quickly
P 7 6 1~500 60
Back sewing electromagnet full output time
ms
P 7 8 10~359
120
clamp thread s
tart angle
P 7 9 0~359
320
clamp thread end angle
P 9
8
0~4 4
Vo
ice volume (0~4),4 maxicum（after factory seeting will not change）
P 9
9
0/1/2 1
Languge
selection 0：voice close ，1：Chinese，2：English，default: Chinese
P A
0
1~9999 5000
The lift foot release down Delay time after remove cloth when sensing turn on.
P A
1
0~600 50
The lift foot release down Delay time with cloth when sensing turn on.
Unit :0.1s