Jack A7-D - System Parameter Settings; Parameter Mode Navigation; System Parameter List (P01-P111)

第
6
页共 10 页
4 System parameters setting list
4.1 Parameter mode
1、In the standby state ,press key to enter the parameter modes.
2、Press corresponding key
and key to adjust the corresponding parameter.
3、When the parameter values have increased and decreased, parameter interfaceflash.Shortpress
key to save the modified
parameters .Long press
key to exit parameter interface, return to standby model.
NO. Range Default Description
P01 200~5000 3800 Free seam velocity
P02 1~100 56 Start sewing slight lift force adjusting
P03 0/1 1 Needle stop position selection (1:up; 0: down)
P04 200~3000 1800
Start back tacking speed
P05 200~3000 1800 End back tacking speed
P06 200~3000 1800
Continuous back sewing speed (W sewing)
P07 200~4000 3700
Multiple seam velocity
P08 0/1 0 Stitching presser foot micro-lift presser foot switch
P09 0/1 0
Soft start switch (0:off; 1: on)
P10 1~9 2
Slow-start stitch count
P11 100~800 400 Slow-start sewing speed
P12 -8~8 2
1/2 multi-function key(2-1/2 4-1/4 8-1/8 -2-(-1/2) -4(-1/4) -8-(-1/8))
P13 200~4000 3200
Maximum speed of reverse stitching
P14 100~800 200 Stitch compensation speed
P15 0~3 1
Button stitching mode (0- close 1- continuous stitching according to the time 2- half stitching 3- one
stitching)
P16 0~9999 0
Thickness detection 0 point value
P17 0~9999 0 Thick material height
P18 0~50 5
A terrier number of threads
P19 200~4000 2000
A terrier speed
P20 0~50 5 Compensation value of over-stalk needle distance
P21 0~50 0
Thickness detection sensitivity
P22 1~4 4
A terrier trajectory
P23 0~4095 1100
Analog quantity of pedal wire cutting position 1(turn off automatic lifting foot pedal wire cutting
position)
P24 0~4095 550
Analog quantity of pedal wire cutting position 2(start automatic lifting foot pedal wire cutting position)
P27 10~100 36
Efforts to cut line
P28 0~359 130 The starting Angle of the clamping line when the front reinforcement joint and the W joint are opened
P29 0~359 320
The clamping end Angle of front reinforcement joint and W joint when opened
P30 0~359 130
The starting Angle of the clip when the front tight seam is opened
P31 0~359 340 The clamping end Angle when the front tight seam is opened
P32 0~100 80
Raise duty cycle gently with presser foot
P33 0~80 55
Clamp wire output
P34 0/1 1 Oil level detection switch
P35 0~3000 800
The speed of the first stitch
P36 0~3000 1500
The speed of the second stitch
P37 0~3000 0 The speed of the third stitch
P38
0~4000 1000
Front reinforcement/W seam first stitch speed limit