Jack ZB-A4F User Manual

1 / 14
ZB-A4F electric control box manual
· Safety Precautions
· Before using this product, please read the User's Guide and the manual of the machine attached with it.
· This product must be installed or operated by professionally trained personnel.
· Please keep away from the arc welding equipment to avoid the electromagnetic wave from interfering with the
controller.
· Please do not use it at room temperature above 45°or below 0°。
· Please do not use it in places with humidity below 30% or above 95% or where there is dew and acid mist.
· When installing the control box and other parts, turn off the power and unplug the power plug.
· To prevent interference or electric leakage accidents, make a good grounding work. The grounding wire of the
power cord must be firmly connected to the earth.
· All parts for maintenance must be supplied or approved by the Company before they can be used.
· The power must be turned off and the plug unplugged before any maintenance action is performed.There is a
high-voltage danger in the control box. You must shut down the power for 5 minutes before opening the control
box.
1 Product Installation
1.1 product specification
Voltage AC 220±20% V
Supply frequency 50Hz/60Hz
maximum output power 550W
1.2 The connection of interface plug
Insert the connecting plugs of the foot pedal and the head of the machine into the corresponding socket at the back of the
controller. Each socket names are shown in figure 1-2-2.Please check whether the plug is inserted.

Jack ZB-A4F Specifications

General

Brand	Jack
Model	ZB-A4F
Category	Sewing Machine
Language	English

Summary

Product Installation

Product Specification

Provides essential technical details including voltage, supply frequency, and maximum output power.

Interface Plug Connection

Details the process of connecting the foot pedal and machine head to the controller unit.

Operation Panel Introductions

Display Introduction

Explains the LCD display and how it shows the current sewing status and needle position.

Key Function Declaration

Details the name, function, and indication of each key on the operation panel.

Parameter Adjustment

Enter Parameter Mode and Saving

Describes how to access, modify, and save system parameters.

Speed Adjustment

Instructions for adjusting the machine's sewing speed using up and down keys.

Factory Setting

Guide on how to reset the machine to its original factory default settings.

Parameter Lists

Technician Mode Parameters

Lists parameters accessible in technician mode, including default values and ranges.

Technician Parameter List (On Entry)

Details parameters available when entering technician mode via power-on switch.

Monitoring Parameter List

Lists parameters for system monitoring, accessed via specific key combinations.

Error Code and Alarms

Error Code List

Provides a comprehensive list of error codes, their meanings, and troubleshooting solutions.

Safety Alarm Meter

Details safety alarm codes, their descriptions, and recommended actions.