8 / 14
3.9.2 Technician Parameter list (Press P and switch on to enter)
Parameter
List
Parameter Name
Default
Value
Parameter
range
Description
P44 Press delay time
0 0-300
0: off
1-300:start according to the delayed time
P47 After trimmer and pull back
360 200-360
P49 Trimmer speed (r/min)
250 100-500
P52
Delaying time of down presser
foot lift (ms)
2 0-500
P53 Press EN
1 0-1
0： Off 1： On
P54 Backlight brightness
100 0-100
P55 Upper thread detection switch
0 0-1
P56
Connect power and finding
needle position automatically
1 0-1
0： No 1：Yes
P58
Adjustment angle of up needle
position
67 0-359
P59
Adjustment angle of down
needle position
176 0-359
P34
Multi-segment sewing motion
mode selection.
0 0-1
0: one key start function off 1: one key
start function off
P35 Thread clamp switch 1 0-1
P36 Threads testing ending angle 25 1-360
P37
Thread clamp magnet closing
time
4 2-10
P38 Trimmer switch 1 0-1
0: off 1：on
P39 Press foot lifter in halfway 0 0-1
0: off 1：on
P40
Switch of auto press foot lifter
after trimming
0 0-1
0: off 1：on
P41 Unit of counter 1 1-50
P42 Setting of total counter 9999 1-9999
P43
Counter mode
0 0-6
0： off
1： Ascending cycle count.
2: Descending cycle count.
3： Ascending accounting to full, alarm and
stop running
4： Descending accounting to 0, alarm and
stop running
5:Ascending accounting to full, remind and
keep running
6： Descending accounting to 0, alarm and
keep running
（note: press P shortly to cancel alarm）
To Next Page
Loading...
Need help?
General
