5 / 14
14
Down key(speed
down)
Enter this mode, adjust this key, decrease speed
15
Key left Turn to left to choose parameter
16
Right selection Turn to right to choose parameter
17
Reset key Press 3 seconds, then back to factory setting
3 Parameter adjustment
3.1 Enter parameter mode and saving
Press , enter parameter mode, then press or to move the lit, corresponding number flashing,
then press or to modify this value, press , save the parameter. If not modified, press to log
out parameter mode, if already modify, firstly save parameter, then press to log out parameter mode.
3.2 Enter technician parameter mode and save it
Press and turn on the machine to enter technician parameter mode.The methods is same as
parameter mode.
3.3 Speed adjustment
Press and to adjust the speed. For up, to adjust fast, for down, to adjust slow.each adjustment
value is 50.
3.4 Factory setting
Press the for a long time, back to the factory setting.
3.5 Enter monitoring system
Press + to enter this mode, press up and down key to adjust this parameter, press P, then can log
out.(if it is24、25、26、28, then press P to save this monitoring value as the corresponding parameter, if save
successfully, show OK, press P for short time to log out this mode. )
PS: Needle position setting, enter monitoring mode number 24, move the hand wheel to up needle position(the value will be
changed with hand wheel position), press for long time to save it(after save it, down needle position will be adjust automatically),
press to log out this mode.
To Next Page
Loading...
Need help?
General
