Jackery Explorer 1500 - Frequently Asked Questions; Device Compatibility and Usage; Charging and Performance Queries

Questions and Troubleshooting
A: The AC output port can charge/power devices that operate at less than 1800 watts.
A: Yes, the Explorer 1500 supports pass-through charging. But we don't suggest it because doing so
will cause damage to battery life.
A: No, the E1500 can't be used as UPS. You need to press the power button to turn on the AC/USB /DC
output. Therefore it can't turn on and off automatically.
A: Working time = 1534.68Wh* 0.85 / operating power of your device (watts).
Q1: What devices can the Explorer 1500 power?
Q2: Can the Explorer 1500 be charged while using?
Q3: Can the E1500 be used as UPS?
Q4: How can I know the working times for my device?
Q6: How do I know the Explorer 1500 is charged?
A: To check the charge level of the Explorer 1500, refer to the LCD Battery Display.
Q5: Does the Explorer 1500 include a built-in MPPT controller?
A: All Jackery power stations have a built-in MPPT controller.
Q7: Can I keep this charged up by keeping it plugged in all the time in case of power outage?
A: Yes, you can keep the battery plugged in to charge. Keeping it plugged in won't cause damage to
the battery.
Q8: Can I use it indoors?
A: Yes, the Explorer1500 is safe to use indoors.
Q9: Why does it take so long to charge the power station from 99% to 100%?
A: When the battery is low, the charging power is greater, so the battery charges faster. As the battery
reaches a higher and higher charge, the difference between the charging voltage and the battery
voltage becomes smaller. This means the battery will charge at a slower and slower rate as it
approaches 100%.
Q10: Can I find any video about recharging the Explorer 1500?
A:Yes! Follow the instructions below to see the product video:
Go to jackery.com.
Click the "Support", and then choose"FAQ."
Find the appropriate video in the "Product Video" section.
12
FAQ