When the power station can't work properly, you can choose to reset the battery to trouble shoot.
GIVE YOUR APPLIANCES MORE RUN TIME
CHARGING
Note:The running time of the E300 for the following equipment are tested in the
laboratory, which has strict controls on temperature, the working hours can also be
affected by many other factors.The actual working time = 293Wh* 0.85 / operating
power of your device.
For inductive load devices:
•What is the inductive load device?
Inductive Loads, also called Lagging Loads or Inductive Load Banks or Inductive
Reactive Loads or Power Factor Loads, are AC loads that are predominantly
inductive in nature so that the alternating current lags behind the alternating
voltage when the current flows into the load.
•The inductive load device has an instant start power when the it runs. Typically
starting power is 3 times the amount of power to run the application.
•When you check if the E300 can run the device, please kindly check if there is an
instant start power.
When the power station has something wrong with input by using AC charger
cable :
•Check if the charger cable and the power station are reliably connected; whether
the charger indicator light is on.
•Check if the original charger is used.
•Whether the charging indicator of the power station power supply is on and
whether the screen displays the charging power.
•Please try to use the provided car charging cable to charge to see.
This troubleshooting is also fit for DC input failure.
TROUBLESHOOTING
PROBLEM WITH INPUT (AC/DC)
RUN TIME
Drone
(90W max)
About
5.8 Recharges
RUN TIME
Motion Camera
(5W max)
About
54 Recharges
RUN TIME
12’’Mac book
(30W)
About
4 Recharges
RUN TIME
Smartphone
(18W max)
About
30 Recharges
RUN TIME
32”TV
(60W)
About
4.5 Hours
05
US
To Next Page
Loading...
