SPECIFICATIONS 11
en-101
11.6 NOISE ___________________________________________________________________
When the machine was tested for sound pressure (Operator Ear).
The Machinery Safety Directive 2006/42/EC
And
Exposure Of Workers To The Risks Arising From Physical Agents (Noise) Directive 2003/10/EC
By compliance to:
The Lawnmower Standard BS EN ISO 5395:2013
And
Sound Pressure Standard EN ISO 3746: 2010
Measured Sound Pressure 88(A) ± 0Leq
When the machine was tested for sound power (Noise in the Environment).
The Machinery Safety Directive 2006/42/EC
And
Noise Emission In The Environment By Equipment For Use Outdoors
Directive 2000/14/EC
By compliance to:
Sound Power Standard EN ISO 3744:2010
Measured Sound Power 103.2dB(A) ± 1.06LWA
11.7 SLOPES _________________________________________________________________
DO NOT USE ON SLOPES GREA
TER THAN 15°. The slope was calculated using static stability measurements
according to the requirements of BS EN ISO 5395:2013
11.8 CUTTING PERFORMANCE __________________________________________________
89 inch (226.1 cm) width of cut:
2.29 hectares/hr. At 11.26 kph.
5.66 acres/hr. at 7 mph
(10% allowance is included for normal overlaps and turning at the end of each cut).
11.9 CUTTER IMPLEMENT SPECIFICATION ________________________________________
AR530
Number of Cutting
Implements
5
Blade Cutting Width 23 inch (58.4 cm)
Height of Cut 0.75 - 4.5 inch (19 mm - 114 mm)
Height of Cut Adjustment Front and rear roller adjustment handles.
Transmission By Hydraulic motor to blade.
To Next Page
Loading...
Need help?
General
