SAFETY 2
en-11
WARNING
Ear protection must be worn when you operate machines with an operator ear noise level of more than 85 db(a) leq.
WARNING
Vibration Exposure Limits
Exposure limits are calculated as a combination of the vibration level (magnitude) of the tool and the Daily Exposure
Time (Trigger Time). E.g. A product with 5m/s² vibration can be used up to 2 hours/day to reach the EAV and up to 8
hours/day to reach the ELV.
Exposure Action Value (EAV) - Daily vibration exposure A(8) = 2.5m/s²
Where daily vibration exposure A(8) is below 2.5m/s² the risk is relatively low and no action need be taken
Exposure Limit Value (ELV) - Daily Vibration Exposure A(8) = 5.0m/s²
If several tools are used the exposure values must be combined:
Total exposure is then the combined value of the activities
WARNING
Never mow if there is a risk of lightning or when you hear thunder. If you are in the middle of mowing, stop in a safe
place, turn off the engine and go inside a building.
CAUTION
When you do any welding on the machine, the battery, controller and display units must be disconnected before you
start. You must not open the controller. If the controller is opened, this can cancel all of the warranties and can cause
the failure of the machine.
CAUTION
Personal Protective Equipment (PPE), For example safety glasses, leather work shoes or boots, a hard hat, leather
work gloves and ear protection must be used after the owner/user completes a local risk assessment of the mower,
to prevent injury.
Training in all manual operations must be given by an approved person before the machine is used the first time.
!
!
!
!
!
To Next Page
Loading...
Need help?
General
