MAINTENANCE AND LUBRICATION 7
en-65
Every 2 Years • Replace oil separator related rubber piping
• Replace DPF related rubber piping
• Replace air intake line and suction air pressure takeout rubber piping.
• Replace Boost sensor rubber piping
• Replace EGR cooler rubber piping
• Replace water rubber piping
• Replace lubricant rubber piping.
• Change engine coolant
• Change radiator hoses and clamps
• Change fuel hoses and clamps@
• Change intake air hoses@
• Replace Alternator Belt (or every 500Hrs)
The items listed above (@ marked) are registered as emission related critical parts by Kubota in the U.S.EPA non
road emission regulation. As the engine owner you are responsible for the performance of the required
maintenance on the engine according to the above instruction. Please see Warranty Statement for detail.
Refer to Engine Manufacturers Manual for the Complete Engine Maintenance Procedures
Fluid Requirements
Quantity Type
Engine Oil (with filter) 7.6 liters 2.4 Imp gals 2 US gals (see specification below)
Hydraulic Oil (with filter) 37.9 liters 12 Imp gals 10 US gals Greens Care 68
Radiator Coolant 7.6 liters 2.4 Imp gals 2.0 US gals 50% Anti-Freeze
Fuel 64.2 liters 20 Imp gals 17 US gals #2-D (ASTM D975) Diesel
Grease as required Shell Gadus 2 or equivalent
Engine oil: Must be to A.P.I. Classification CJ-4 grade or higher.
TEMPERATURE VISCOSITY
Above 25°C (77°F) SAE30 or SAE10W-30 or 10W-40
0°C to 25°C (32°F to 77°F) SAE20 or SAE10W-30 or 10W-40
Below 0°C (32°F) SAE10W or SAE10W-30 or SAE10W-40
TIRE PRESSURE
Front Wheel Rear Wheel
Tire Size Tire Type Tire Pressure Tire Size Tire Type Tire Pressure
26.5 x 14.00 - 12
Ultra Chevron
6pr
12-14 psi
(0.82-0.97 BAR)
20.00 x 10.00 - 8 Grass Master 4pr
12-14 psi
(0.82-0.97 BAR)
Lubrication Points (Grease Every 50 Hours)
A. Steering axle pivot) E. Lift Arm Pivot (8)
B. Tie Rod Ball Joints (2) F. implement Pivot (5)
C. Steering Cylinder Ball Joints (2) G. Rear implement Roller (10)
D. Lift Cylinders (8)
To Next Page
Loading...
Need help?
General
