7.10 TRANSPORTING ON A TRAILER OR FLATBED
Use straps over the front wheels (A) and the loop at the rear (B) to fasten the mower to the transport vehicle.
Make sure that all tie down straps are tight. Make sure that the decks are locked in the transport position. Check
the fuel and hydraulic tank caps are tight. Make sure that no part of the mower can fall during transport.
Always follow the given maximum transport load weight for the vehicle used.
Do Not carry more than the maximum weight shown on the transport vehicle plate.
Slinging
When slinging the mower, damage free clamps must be used, see the
illustration, with an approved lift frame. Information is available at
www.tipnlift.co.uk.
Jacking
The machine jack points indicated by the decal shown.Two for each axle on
four wheel vehicles. Other axle types are different, check the Safety and
Operations Manual for the safe jack points
OPERATION 7
To Next Page
Loading...
Need help?
General
