Jacobsen HR-9016 Turbo 70528 User Manual (English)

Questions and Answers:

M
Marcus GrahamJul 31, 2025
Why my Jacobsen HR-9016 Turbo 70528 Lawn Mower engine will not start?
- M
  Michael BrownJul 31, 2025
  If your Jacobsen Lawn Mower engine won't start, there are several potential causes. First, ensure the parking brake is engaged and the power take-off switch is off, following the correct start-up procedure. Check that the glow plug has timed out by resetting the ignition switch. Inspect the battery and its connections for any issues. Also, verify that the fuel tank is not empty or contains dirty fuel, and replace the fuel filter if needed, bleeding the fuel lines. Other possible causes include a blown fuse (replace it), defective relay(s) (test and replace), the traction pedal not being in neutral (check and adjust the linkage), or a faulty neutral or forward sensing switch on the drive pump (test, adjust, or replace).
K
Kevin PriceAug 5, 2025
How to fix a Jacobsen Lawn Mower engine that is hard to start?
- B
  Barbara CookAug 5, 2025
  If your Jacobsen Lawn Mower engine is hard to start or runs poorly, start by checking the fuel level and condition, replacing the fuel filter and bleeding the fuel lines if necessary. Inspect and replace the air filter if it's dirty. For issues related to the injectors or fuel pump, or for more complex engine problems, consult the engine manual.
K
kenneth85Aug 11, 2025
Why is my Jacobsen Lawn Mower engine overheating?
- A
  Amanda BerryAug 11, 2025
  If your Jacobsen Lawn Mower engine is overheating, begin by checking the coolant level and adding coolant if it's low. Ensure that the air intake at the radiator is clean and not restricted. If the water pump belt is broken or loose, tighten or replace it, referring to the engine manual for specific instructions.
C
Christine MccannAug 15, 2025
What causes a Jacobsen HR-9016 Turbo 70528 Lawn Mower battery to not hold charge?
- R
  Robert HughesAug 15, 2025
  If the battery on your Jacobsen Lawn Mower is not holding a charge and the battery light is on, inspect and clean any loose or corroded battery terminals. Check the electrolyte level and refill if low. If the alternator belt is loose or broken, tighten or replace it, consulting the engine manual. For defective charging system, refer to the engine manual.
M
Michael WilliamsAug 20, 2025
What to do if my Jacobsen HR-9016 Turbo 70528 engine stops?
- A
  Alexandra DonovanAug 20, 2025
  If your Jacobsen Lawn Mower engine stops, first check if the fuel tank is empty and refill it with fresh fuel, bleeding the fuel lines. Also, make sure all interlocks are properly set before leaving the operator’s seat by engaging the parking brake and setting the power take-off switch to OFF.
E
Erik KingAug 26, 2025
How to fix Jacobsen Lawn Mower cutting units not cutting evenly?
- J
  Jeffrey CarterAug 26, 2025
  If the cutting units on your Jacobsen Lawn Mower are not cutting evenly, ensure that the cutting heights are set evenly by checking that the decks are level and adjusting the cutting height as needed. Verify that the engine speed is correct with the throttle in its fast position. Adjust the mow speed to suit the turf conditions for the best cut. Check the air pressure in the caster tires and adjust to the correct pressure.