Need help?Do you have a question about the Jacobsen HR-9016T 70541 and is the answer not in the manual?
General| Cutting Width | 60 inches |
|---|---|
| Engine Type | Diesel |
| Transmission Type | Hydrostatic |
| Cutting Height Range | 0.25 - 2.5 inches |
| Fuel Tank Capacity | 12.5 gallons |
| Cutting Height | 0.25 - 2.5 inches |
Introduces the manual's purpose, scope, and intended audience for repair and troubleshooting of Jacobsen mowers.
Notes on California Proposition 65 warnings and acknowledged trademarks within the manual.
Emphasizes safety's importance and outlines essential preparation steps for safe repair work.
Explains safety alert words, label locations, and safe practices for work areas, including ventilation and protection.
Covers safe machine parking, lifting, support, and usage of air tools and lifting equipment.
Safety precautions for servicing tires, handling fuel, volatile materials, chemicals, and air tools.
Safety measures for hydraulic, cooling, and electrical systems to prevent injury and damage.
Safety for electrical components and proper disposal of waste materials to protect the environment.
Details machine serial numbers, identification plates, and key component locations with visual references.
Covers general engine specs, repair torque values, electrical test specs, and solenoid torque.
Lists hydrostatic power train specs (flow, pressure, leakage) and hydraulic system test/repair values.
Includes steering specs, cutting unit torques, caster wheel specs, and tire pressure/torque.
Specifications for brakes, fuel tank, wheel hubs, mower speeds, weight, and general machine dimensions.
Provides reference charts for inch and metric fastener torque values based on grade and lubrication.
Details general engine specs, repair specs, and component locations for the Kubota V3800DICR-T-E3B engine.
Covers procedures for checking and adjusting the fuel system, specifically purging air.
Instructions for servicing fan belt, air cleaner assembly, muffler, and exhaust system.
Procedures for servicing the coolant recovery tank, radiator/oil cooler, and engine oil cooler.
Steps for servicing thermostat, throttle lever, sedimentor filter, and fuel filter.
Procedures for servicing fuel pump and complete engine removal/installation.
Details engine mounting, wire harness securing, final checks, and refers to manufacturer's service manual.
To Next Page