Jacobsen Ransomes HR 6010 User Manual

Service Course Manual
HR 6010
Serial Range: EA
WARNING: If incorrectly used this machine can cause severe
injury. Those who use and maintain this machine should be
trained in its proper use, warned of its dangers and should
read the entire manual before attempting to set up, operate,
adjust or service the machine.
®
GB

Jacobsen Ransomes HR 6010 Specifications

General

Brand	Jacobsen
Model	Ransomes HR 6010
Category	Lawn Mower
Language	English

Summary

Section 2: Controls

Control System Overview

Introduction to the machine's control layout, including starter key and pedals.

Operator Controls: Starting and Speed

Operation of starter key, throttle, and speed limiter for engine and travel.

Steering and Speed Limiter

Adjustment of steering wheel rake and use of the speed limiter for cutting/transport.

Transport and Parking Controls

Operation of transport latches and the parking brake system.

Hydraulic Lift Lever Operation

Cutting Unit Switch Operation

Instrument Panel and Indicators

Description of gauges, warning lamps, and switches on the instrument panel.

Section 3: Engine

Engine Specifications

Engine Technical Data

Engine Maintenance: Oil, Filter, Fuel

Procedures for changing engine oil, filter, and fuel system maintenance.

Cooling System Servicing

Section 6: Hydraulics

Hydraulic System Overview

Hydraulic Schematics: Steering and Lift

Hydraulic Schematics: Decks Lowered and Cutting

Hydraulic Schematics: Forward Drive Transport

Hydraulic Schematics: Forward Drive Diff-Lock

Hydraulic Schematics: Reverse Drive

Section 7: Electrical System

Electrical System Overview

Fuse and Relay Locations

Identification and location of main/secondary fuses and relays.

Operational Electrical Schematics

Wiring diagrams illustrating various machine operating states.

Section 8: Preventative Maintenance

Lubrication and Fluid Requirements

Maintenance Schedule and Procedures

Comprehensive chart detailing maintenance tasks and intervals.

Cutter Deck Belt Tension Adjustment

Procedure for adjusting belt tension on center and wing cutter decks.

Blade Sharpening and Removal

Instructions for sharpening, balancing, and replacing cutter blades.