CONTROLS 6
en-30
The red hydraulic-level light indicates a low-fluid level in the hydraulic tank. Immediately stop the engine.
Visually inspect the mower for indications of leaks around connections, hoses and hydraulic components.
Return the mower to the service area for maintenance.
The red hydraulic filter light indicates that the hydraulic filter must be replaced. Return the mower to the
service area and replace the filter.
The red fault light indicates the controller system has sensed a fault. See fault message shown on the LDU.
When a Parked Regen cycle is necessary, the yellow Regen Request light will flash. During a Parked Regen
cycle, the Regen Request light will illuminate. When a Tier 4 Interim engine is installed, this light will not
operate.
The yellow high-exhaust temperature light indicates that an Active or Parked Regen cycle is active and a
high exhaust temperature is sensed. When a Tier 4 Interim engine is installed, this light will not operate.
WARNING
The hydraulic fluid is under pressure. To prevent injury, do not use your hands to find hydraulic leaks, use
paper or cardboard. Allow the hydraulic fluid to become cool before you check the fluid level or you add fluid
to the hydraulic tank.
!
!
To Next Page
Loading...
Need help?
General
