12 QUALITY OF CUT
en-79
12.3 MARCELLING ____________________________________________________________
NOTE: Arrow indicates direction of travel.
Marcelling is a repeated pattern of different cutting
heights, that causes an appearance that is like a wave. In
most cases, the wave tip-to-tip distance is 2 in. (5 cm) or
less.
Probable Cause Remedy
The cut (ground) speed is higher than normal. Reduce the cut (ground) speed.
The HOC (height-of-cut) settings is too low for the turf
conditions.
Check HOC adjustment of cutting units.
The cutting reel diameter is worn. Check the cutting reel diameter and replace if necessary.
To Next Page
Loading...
