SAFETY 3
6
h Equipment must meet the current regulations to be
driven on the public roads.
i Before you move across or operate on the paths or
roads, turn off the PTO switch, lift the mowers and
travel at decreased speed. Look for traffic.
j Stop the blades when the mower is on any surface
that is not grass.
k Do not release the cut grass in the direction of
persons or allow persons near the mower while in
operation.
l Do not operate the mower with damaged guards or
without safety devices in position.
m Do not change the engine governor setting or over
speed the engine.
n Before you leave the operator compartment, for
any reason:
– Disengage all the drives and lower attachments to
the ground.
– Turn the parking brake switch to the ON position.
– Stop the engine and remove the key.
o When you hit an object or mower starts to cause
the vibration that is not normal, inspect the mower
for damage and make the repairs.
p Decrease the throttle setting before you stop the
engine. Stop the engine, turn the fuel valve to the
closed position.
3.1.4 MAINTENANCE AND STORAGE
a When the mower is parked, put into storage or left
without an operator, lower the cutting device unless
a positive mechanical lock is used.
b Keep the engine clean. Allow the engine to
become cool before storage and always remove
the ignition key.
c Keep all nuts, bolts and screws tight to make sure
the equipment is in safe condition.
d Replace worn or damaged parts for safety.
e To decrease the fire hazard, remove the grass, tree
leaves and grease from the engine, muffler, battery
tray and fuel tank area.
f Disconnect the battery and controller electrical
connectors before welding on this mower.
This mower is not for use on rough terrain or long
grasses.
To Next Page
Loading...
