CONTROLS 4
10
4.2.1 IGNITION SWITCH _________________________________________________________
The ignition switch has three positions, OFF, RUN and START. In the run
position, the controller program is active and input and output circuits are
monitored.
4.2.2 PARKING BRAKE SWITCH __________________________________________________
To engage the parking brake, move the orange lock toward front of mower and press
the front of the switch. Parking brake light on combination gauge (See 4.2.17) will turn
on. Operation of the cutting units operation is disabled with the parking brake engaged.
To disengage parking brake, press the rear part the switch. The parking brake light will
turn off.
NOTE: Engine will not start with the parking brake switch in the OFF position.
4.2.3 HORN SWITCH ____________________________________________________________
Press the front of the switch to use the horn.
To Next Page
Loading...
Need help?
General
