Jacobsen SLF530 - One Touch Mode Setting; Change PIN for Settings

CONTROLS 4
en-30
4.2.6.27 ONE TOUCH____________________________________________________________
Navigate to the PIN Menu. See 4.2.6.14
Use the UP and DOWN arrow keys until the green arrow is
next to One Touch. Press the select button to select One Touch.
Use the UP and DOWN arrow keys until the green arrow is
next to Enable or Disable. Press the select button to accept.
Disable - The cutting units lift or lower only while the lift/lower joystick is
pushed or pulled.
Enable - Joystick is pressed and released to lower the cutting units or to lift the
cutting units.
Press the back button to return to previous menu.
4.2.6.28 CHANGE PIN ___________________________________________________________
Navigate to the PIN Menu.See 4.2.6.14
Use the UP and DOWN arrow keys until the green arrow is
next to Change PIN. Press the select button to select Change Pin.
Use the arrow keys to highlight the new correct number. Press the select
button to enter the number and to advance to the next position. Repeat until
all four numbers of the pin have been entered.
Select . To accept.
Press the back button to return to previous menu.
One Touch
Disable
Enable
PIN Menu
One Touch
Change PIN
Set Default Parameters
Reset Service Hours
PIN Menu
One Touch
Change PIN
Set Default Parameters
Reset Service Hours
Change PIN
1001
123
456C
7890