MAINTENANCE AND LUBRICATION 8
en-60
Check The Engine Coolant Level
1. The level of coolant in a cold expansion tank must be
between the MIN and MAX indicators.
2. If you need to fill the tank, remove the expansion tank cap
and fill with the correct anti-freeze mixture (See Section
8.1).
3. Replace the plastic cap.
How To Change Coolant
1. To drain coolant, remove the bottom hose (A) from the radiator. Drain the engine coolant into a container.
2. Connect the bottom hose (A) to the radiator. Make sure all the hose clamps are tight.
3. Fill the cooling system with the correct anti-freeze mixture (See Section 8.1). Fill system through the expansion
tank.
4. The level of coolant in a cold expansion tank must be between the MIN and MAX indicators.
5. Run the engine for approximately 5 minutes or until the thermostat opens.
6. Check the level of coolant in expansion tank. Fill the tank if more coolant is needed.
WARNING
To prevent injury from the hot-engine coolant or steam,
never remove the expansion tank cap with the engine in
operation. Stop the engine and wait until the radiator is
cool. When radiator is cool, use caution to remove the
expansion tank cap.
CAUTION
Anti-freeze can damage your skin. Use gloves when you use anti-freeze. If anti-freeze touches your skin,
clean the area immediately.
CAUTION
Discard anti-freeze in accordance with local safety regulations.
To Next Page
Loading...
Need help?
General
