Jacto J600 User Manual

03/23/05 J600CHT Assembly – DRAFT Prepared for Jacto
Service Seminar 3/2005
DRAFT COPY
J600 CHT Assembly
1) Remove the sprayer and components from the crate it was shipped in. In the crate
you will find the following components to assemble: main outlet duct, stationary
duct, control valve, vertical hydraulic cylinder and brackets, clean water tank and
bracket, side step, auxiliary ducts and JA nozzles, fan cage cover for disconnect, and
accessory box with the required fasteners to assembly the sprayer.
Accessory Box
The above picture shows the parts that you will find inside the accessory box. The
hardware will be used in the assembly of the sprayer. You will also notice that there
is 2 vertical cylinder brackets, pivot bushings for duct, pin for vertical cylinder, fan
disconnect cover, plate for attaching the fresh water tank bracket, 6 JA nozzles with
swirl cores, hose retaining clip, spanner wrench, and pins for your convenience when
attaching the sprayer to the tractor. You will also find the operator’s manual.

Jacto J600 Specifications

General

Brand	Jacto
Model	J600
Category	Stairlifts
Language	English

Summary

Accessory Box Contents

Control Valve Installation

Stationary Duct Assembly

Movable Duct Assembly

Hydraulic Cylinder Assembly

Auxiliary Duct Assembly

PTO Shaft and Clean Water Tank Installation

PTO Shaft Installation

Install the PTO shaft by aligning the key way and securing it with the retaining bolt.

Clean Water Tank Installation

Mount the clean water tank bracket and then install the tank into the bracket.

Final Assembly and Setup

Side Step and Fan Cage Assembly

Install the side step and the center piece for the fan cage.

Final Inspection and Checks

Perform final inspection of fittings, fasteners, and check gearbox oil level.

Tractor Attachment and PTO Setup

Attach sprayer to tractor hitch and adjust PTO shaft length; engage PTO.

Water System Priming

Add water to the tank and prime the pump to bleed out any air.