8.2 LCD Display
A. Lock Symbol indicates panel, set temperature, or filter cycle
programming is locked.
B. Heat Symbol: indicates heater is on (Sec. 9.1, Page 17).
C. Ozone Symbol indicates the optional CD Ozonator is on Sec. 13.3,
Page 40).
D. General Indicators: show which skimming/heating cycle is in
progress or display selected skimming/heating cycle programming
features (Sec. 11.2, Page 30).
E. Set Indicators: these characters identify what is being shown on
the main 4-digit display.
F. Indicates programmed filter cleaning interval has elapsed (Sec.
11.3 Page 31).
G. Light Symbol: indicates spa light is on.
H. JETS 1 Symbol indicates 2-speed pump #1 is on. The symbol
changes according to speed selected and flashes during an
automatic operation.
I. JETS 2 Symbol indicates the following:
• On J-350, J-360, J-370 models, this symbol indicates high-speed
pump #2 is on.
• On J-380 models, this symbol indicates either high-speed pump
#2 and/or pump #3 are on.
J. Mode Annunciators: these characters identify which skimming/
heating mode is currently selected (Page 28).
Page 13
To Next Page
Loading...
