99
5-6 cm
HYDROMASSAGE
Turn on the main switch and wait a few seconds until the
start-up process has completed.
NOTE: check that there are no objects resting on the control
panel (located above the tub edge).
To activate the hydromassage, press the button (on the
tub edge); repeat to disable this function.
NOTE: the hydromassage will turn itself o automatically after 20
minutes.
We recommend leaving the hydromassage active for a dura-
tion of 15-20 minutes (5-10 minutes are necessary before the ac-
tion of the moving water begins to take eect).
We recommend setting the water temperature at approxi-
mately 36 °C; in the instance of higher temperatures, it is advis-
able to reduce the duration of the hydromassage:
34-36 °C --> 20 minutes of hydromassage
36-38 °C --> 15 minutes of hydromassage
38-40 °C --> 10 minutes of hydromassage
Soap and bath foams (where not used as part of hydromas-
sage) must only be used when the hydromassage is not in
use.
Always turn o the hydromassage and main switch before
emptying the tub.
LIGHT (where present)
To switch on the light, press the button for a few seconds
(on the tub edge).
To switch it o, press down the button until the light goes out.
It is possible to have either a white or coloured light; a light
which changes colour assuming dierent sequences is also
available.
The colour sequences are as follows:
- Cromodream (based on a mixed colour sequence);
- Relax (based on a blue colour sequence);
- Energy (based on a red colour sequence).
1
3
4
2
To Next Page
Loading...
