45
Shower area
- check that the mixer is open; in models with thermostat mixer, also check that the stop
tap is open and that the lters are not obstructed (see “Installation manual - Disassembling
and cleaning the thermostat valve”).
- check that the plumbing system complies with the pressure values shown on the pre-in-
stallation sheet. In models with thermostat mixer, check that the lter are not obstructed
(see “Installation manual - Disassembling and cleaning the thermostat valve”).
- clean the lter located between shower and hose.
- clean the nozzles (see “Maintenance” chapter).
- in models with thermostat mixer, check that the lter are not obstructed (see “Installation
manual - Disassembling and cleaning the thermostat valve”).
- check that the pressure value between hot and cold water are balanced.
No water from the various
functions (shower, etc.)
Little water from all functions
Low pressure from
shower/vertical hydromassage
Difficulty in adjusting
water temperature (mixing)
To Next Page
Loading...
