46
Maintenance
■ Remove the screw and cover (be careful not to release the clip of the inside ap).
■ Clean the nozzle compartment with a strong jet of water and liquid soap, if required. Be
careful to clean the seal of the hatch and the valve on the bottom.
■ Then ret the cover making sure that the o-ring is inserted well in its housing.
■ Remove the ange cover (1) by levering under the edge with a wide at tipped screw-
driver.
■ Remove the ring (3) and the nozzle (4) by releasing the tabs.
■ Remove residues and wash the various components with water and liquid soap. The
nozzle can be removed: be careful not to loose the clip inside.
■ Repeat the procedure in the reverse order and make sure that the ring (3) is fastened
well.
Suction nozzles
Hydromassage nozzles
W
e always recommend carefully reading the manual; in the instance that there is an issue,
refer to the following guide.
To Next Page
Loading...
