J-100
9.0 Control Functions
9.1 Control Panel
A. Menu Button ( ): Allows
access to the programming
menus.
B. LCD Display: Can display current
water temperature (default display), water temperature set point,
selected ltration or heating mode, and error messages. Displays a
heat icon ( ) when the feature is on.
C. Warmer Button ( ): Increases water temperature set point.
Increments of 1°F or 0.5°C.
D. Cooler Button ( ): Decreases water temperature set point.
Increments of 1°F or 0.5°C.
E. Jets 1 Button (
1
): Turns jets pump #1 on and off. Press once for
low speed; press a second time for high speed; press a third time to
turn pump off.
F Jets 2 Button (
2
) (if equipped): Turns high-speed jets pump #2
on and off. Press once to turn pump #2 on; press a second time to
turn pump #2 off.
G. Light Button ( ): Turns accent lights on in one of three random
modes or one of seven solid colors. Refer to Section 10.3 (page
27) for details.
Operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default
setting is 100°F (38°C).
• LED light system: All LED lights run for 2 hours and then
automatically shut off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
1
2
B
A
E
C
D
F
G
2-pump control panel shown
24
To Next Page
Loading...
