47
Electronic Device Connections and Functions
CAUTION: RISK OF ELECTRICAL SHOCK OR EQUIP-
MENT DAMAGE! Never install, remove or operate any
electrical device (e.g. Apple device/AUX/Bluetooth)
while hands are wet or while sitting partially or fully im-
mersed in the spa!
Connecting Your Auxiliary Player Using the 3.5 mm Cable:
- Remove the front panel on the hot tub and identify the stereo
unit.
- Locate the cable marked “AUX”, connected to the stereo unit.
- Use a RCA-3.5 mm cable (not supplied) to
connect an external reader to the “AUX” ca-
ble.
- Feed the cable and the reader towards the
outside and ret the front panel on the hot tub
(take care not to damage the cable). Position the reader in a safe
place.
- Press the Mode button on the remote to “AUX IN.
- All playback operations are conducted via the Auxiliary Player.
The stereo remote functions do not work on the external Auxil-
iary Player (except volume control).
Connecting Your Bluetooth Device:
• Turn power “ON” to the stereo unit.
• From your Bluetooth device, make sure the Bluetooth set-
ting is “ON.”
• Follow the pairing instructions for your Bluetooth device
and connect to the "AQUATIC AV" or “BLUEWAVE” device
that appears on your screen.
• If asked for a password, enter the code “0000.”
• The remote LCD screen will display, “BT AUDIO” if the pro-
cess was successful.
• While it is possible to connect a second Bluetooth® device,
music can only be played from one device at a time.
Operating Your Bluetooth Device
Note: the tracks can be selected and the volume adjusted either us-
ing the remote control or the Bluetooth® device. For any other set-
tings, use the Bluetooth® device.
• Press the button to pause the track. Press it again to
restart the track.
• Press the or
button to select the track.
• Press the volume up or down buttons to adjust volume level
between 0 to 20 (on the remote).
Recharging the remote control battery
The remote control has a lithium battery which needs to be re-
charged when “LOW BATT” shows on the screen.
To do this, connect the USB cable supplied to a charger with an
output voltage of at least 5 V (direct current).
WARNINGS
> Do not connect any other devices to the stereo unit.
> Do not try to open/replace the parts of this appliance. Al-
ways contact an authorised Jacuzzi® service centre.
> Disconnect the hot tub and contact a qualied technician
where:
-the conductors/power sockets are worn;
- water leaks inside the compartment where the appliance
is installed;
- the closing panels show signs of wear and/or are dam-
aged;
- there is a fault with the hot tub.
For all special maintenance work, we recommend contact-
ing an authorised Jacuzzi® service centre.
Note: remote unit is water resistant not waterproof. Although it is
designed for use while in the spa, it should never be left in the spa
while the cover is on and spa is not in use.
The remote should be stored in a dry place, away from sources of
heat, as well as frost and bad weather.
To Next Page
Loading...
Need help?
General
