Installation & Operating Instructions
Sliding Door Adjustment
The sliding doors have been factory adjusted for shipping purposes. It will probably be necessary to readjust the
doors prior to use.
With the sliding doors in the closed position, check to make sure that the magnetic strips on each door make
contact with each other for the full length of the door. Also check to see that each door rolls smoothly.
If the magnetic latch does not engage correctly or the doors do not roll smoothly, it will be necessary to loosen
and adjust the position of the door roller or rollers to correct these conditions. It may be necessary to readjust all
(4) rollers on each door. (See illustration below.)
Caution: Do not over tighten rollers. This can result in damage.
Note: There should always be clearance between the bottom edge of the door frame and the top surface of the
lower enclosure frame to prevent the paint coating from being damaged.
After doors have been properly adjusted, install white plastic caps (provided) on all interior screw heads and hex
nuts.
10
To Next Page
Loading...
Need help?
General
