54
This mess age will appear when the filter reminder time has
expired.
I The ProClarity Depth filter must be replaced.
“WATER REFRESH REMINDER”
This mess age will appear when the “Water Refresh” timer has
expired.
I The water needs to be drained and refilled with fresh water.
“EXTENDED TEMPERATURE ACTIVATED”
The spa is set to go up to 40°C (10 4°F), but it can be set to
reach 41°C (10 6°F). To access the extended temperature you
need press and hold your finger over the temperature reading
for about 5 seconds. The temperature reading will start to blink
to indicate the system is ready. Tap (
) to raise the tem-
perature up to 41°C (10 6°F).
Note: The heater icon ( ) will be blinking to indicate that
the feature is active.
Troubleshooting Procedures
In the unlikely event y our spa is not working the way y ou believe
it should, please first review all the installation and operating
instructions in this manual and check the message on the panel
display; second, if y ou are still not satisfied it is working prop-
erly, please follow the appropriate troubleshooting instructions.
NONE OF THE COMP ONENTS OPERATE
(i.e. pump, light)
Check the control panel lights.
I If there are letters or symbols displayed on the screen, refer to the
previous section (Error/Display Messages) to determine meaning and
action required.
I If nothing appears on the display:
- Check the household circuit breaker.
- Contact dealer or authorized service center.
PU M P D OE S NOT OPE RATE
Activate the “JETS”
I If no sound is detected or if a buzzing sound is detected, turn
off power to the spa and contact your dealer or authorized serv-
ice center.
I If motor operates but no water flows to jets:
- Pump may not be properly primed. See instructions below.
- Contact dealer or authorized service center.
Pump priming instructions:
TU R N S PA OFF
- Turn off the power to the spa.
- Remove the handle from the massage selector supplied by
the pump you are priming.
- Loosen the massage selector’s cap slightly (counterclockwise),
listening for the air to seep out.
- Tighten the cap finger-tight, replace the handle and turn the
hot tub’s power back on.
Note: This method must be used for the jet’s pumps because
these pumps are not connected to the main filter system in any
way.
CAUTION: If freezing conditions exist and pump is not oper-
ational, take measures to protect the system from possible
damage from freezing. S ee “Winterizing”.
POOR J ET ACTION.
- Make certain the jets pump is turned on.
- Check position of massage selectors.
- Open air control for selected jet system.
- Check for adequate water level.
- Check for dirty filter
WATER IS TOO HOT.
- Reduce thermostat setting.
- Switch hot tub to “Econo” mode to turn heater on only during
pre-programmed time.
- Make sure the pumps are turned off and not constantly run-
ning.
NO H EAT
- Check thermostat setting.
- Keep the cover in place while heating.
- If heater indicator is displayed, but no temperature increase is
experienced after a reasonable period of time, contact your
dealer or authorized service center.
FI LTE R /CIRCULATI ON PUMP OFF
- Verify filter/circulation pump is programmed to run 8 hours a
day.
- Make sure there are no errors preventing the pump from turn-
ing on.
- Hot tub water is warmer than 95°F (34°C) and two degrees
warmer than the set temperature. The “Summer Logic” safety
feature has activated.
It’s time to replace your ProClarity Depth
Filter. Contact your authorized dealer for a
new filter.
Reminder
reset
snooze
Your spa needs to be drained and refilled
with fresh water. Refer to your owner’s
manual for draining procedure.
Reminder
reset
snooze
ON
To Next Page
Loading...
Need help?
General
