Optional Mounting Stand
An optional mounting stand is also available for situations where the JMC16 cannot be
installed directly above your pool pump.
Installation with optional Mounting Stand
Plumbing
1. Check that the incoming water pressure is within the filter’s recommended working pressure and
ensure that a pressure limiting valve is installed if using mains water or a high pressure pump.
2. Ensure that a foot valve / non return valve are installed if the pump is installed 20” above the water
level.
3. If the filter is installed below the water level or connected to mains water, isolation valves should
be installed at the inlet and outlet of the media filter. This will prevent water flow during any
routine maintenance.
4. Minimize the length of pipe and the number of fittings to minimize restrictions to water flow.
5. Ensure that all plumbing connections are glued and tightened securely to prevent leaking.
6. Ensure solvents are not excessively applied to fittings as this could run into “o”-rings and create
sealing problems.
7. Do not over tighten fittings or adapters.
English
JMC16 | pg 10
To Next Page
Loading...
Need help?
General
