To Next PageTo Next PageWhy is there high pressure on startup of my Jacuzzi JMC16?
High pressure upon starting your Jacuzzi Swimming Pool Filter can be attributed to a few reasons. The eyeball fitting in the pool/spa might be too small. A valve on the return line could be partially closed. Alternatively, the pump might be too large; double-check its selection.
Why is the water in my Jacuzzi Swimming Pool Filter not clear?
Unclear water in your Jacuzzi Swimming Pool Filter can result from several factors, including insufficient disinfectant level, incorrect pool chemistry, heavy use, dirt, incorrect flow, or a dirty filter. It may also be caused by a hole in the filter element, an air leak on the suction line, blocked pump impeller vanes, other restrictions such as pool suction cleaners or inline equipment strainers, or the pump not being primed. To address this, increase pump run time and clean the filter.
General| Brand | Jacuzzi |
|---|---|
| Model | JMC16 |
| Category | Swimming Pool Filter |
| Language | English |
Hair can become entangled in suction outlet cover.
Limb caught in damaged outlet can cause mechanical bind or swelling.
Negative pressure on large body portion can cause entrapment.
Negative pressure on intestines through unprotected outlet can cause evisceration.
Jewelry, hair, etc. caught in outlet opening causes mechanical entrapment.
Explains the centrifugal water filtration principle used by the JMC16.
Details the easy cleaning process for the JMC16 sediment chamber.
Highlights how JMC16 reduces media filter backwash frequency, saving water.
Explains JMC16's role in reducing cartridge filter maintenance needs.
Graphical representation of head loss versus flow rate for the JMC16 unit.
Instructions for flushing the JMC16 sediment chamber with or without pump running.
Lists possible causes and solutions for unclear pool water.
Lists possible causes and solutions for low water flow issues.
Lists possible causes and solutions for short filter cycles in the system.
Lists possible causes and solutions for high pressure during system startup.
