START UP PROCEDURE
The JMC16 is an advanced and highly efficient filter system that will provide years of
trouble free service if the following maintenance procedures are maintained.
To start up the filtration system either from new or after cleaning is exactly the same.
1. Ensure that the JMC16 is plumbed correctly.
2. Ensure that all valves installed before and after the JMC16 are open.
3. Loosen the air release valve on top of the JMC16 filter.
4. Prime the swimming pool pump. (Refer to the pump installation and operation manual).
5. Turn on the swimming pool pump and allow the pump to run until all the air has been
expelled from the JMC16. Water will run from the air release valve.
6. Re-tighten the air release valve.
7. The filter is primed and ready for operation.
Note: In some cases this may be required to be done a few times before the unit will
remain primed and be fully operational.
Do not stand over the top of the JMC16 while adjusting the air release valve to
purge the system of air.
Injury may occur if air release valve becomes loose.
English
JMC16 | pg 12
To Next Page
Loading...
Need help?
General
