Page 19 of 32 IS3206VSP3J Rev-A
1. Preset Speeds: Buttons labeled SPEED 1 thru SPEED 4 can be used to run the pump at a predetermined speed until
the next programmed timer is scheduled to begin. Preset Speed settings can be quickly updated using the + and -
arrow buttons to change the speed and then pressing the > button to save the new speed setting if desired.
a. Default Speeds:
Speed 1: 1150 rpm
Speed 2: 1725 rpm
Speed 3: 2300 rpm
Speed 4: 2875 rpm
2. Menu/navigation buttons: The MENU button will scroll through the setup menus when pressed. The < and >
arrow buttons are used to move between displays and to select parameters to edit, and the + and - arrow buttons are
used to change parameters.
3. Stop/Resume: This button is used to stop the pump to allow strainer basket cleaning, etc. When this button is
pressed, the pump will remain stopped until the button is pressed a second time to resume normal operation.
4. Quick Clean: QUICK CLEAN is a mode intended for use when the pool will be cleaned with a suction side vacuum.
6.4. Menu Outline
1. Configuration Menu (see section 6.6 for basic product configuration)
a. Display Language
b. Set Day and Time
c. Speed Selection
d. Max Allowed Speed
e. Min Allowed Speed
f. Prime Duration
g. Remote Control Mode
h. Low Temp Operation
i. Low Temp Setting
j. Password Protection
k. Password Timeout
l. Set Password
2. Timer Menu (see section 6.7 to program the 8 speeds with timer functions)
a. Rename Timer “X” (where “X” equals 1 through 8)
b. Pump Speed for Timer “X” (where “X” equals 1 through 8)
c. Start/Stop Time for Timer “X” (where “X” equals 1 through 8)
d. Choose Days for Timer “X” (where “X” equals 1 through 8)
3. Preset Speed Setup Menu (see section 6.8 to program the 4 preset speeds)
a. Speed “X” Name (where “X” equals 1 through 4)
b. Speed “X” Speed (where “X” equals 1 through 4)
4. Diagnostics Menu (see section 0 to view product diagnostic information)
a. Display Firmware Revision
b. Drive Serial Number
c. Motor Drive Firmware Revisions
d. Event Log (if applicable)
To Next Page
Loading...
Need help?
General
