22
CALL NOW 800.798.1779
www.infraredsauna.com
SANCTUARY 2
Assembly Instructions Cont’d
The side wall panels will be connected to the back wall by connecting together the installed brackets. There are
“+” brackets and “-” brackets on the side of each panel. The side walls will be installed as follows:
1. Place the left side wall in the slot in the floor.
Lift the side wall up about 4” (10cm) higher
than the backwall panel (See Picture 1).
2. Place the side wall panel against the back wall
(See Picture 2), then slide down side wall panel
until the two panels are equal height. (See
Picture 3).
3. If the panels are not equal height or there is
an obvious gap between the two panels, this
means they are not propery attached and you
should try again.
4. Repeat the steps above for the right side wall
panel.
4 - CONNECTING SIDE WALLS
Right Side Wall Installed
Picture 1 Picture 2 Picture 3
Left Side Wall Installed
If the panels still seem too tight to come
down all the way, try backing off the
bracket screws by one half turn with a
Phillips head screwdriver on the female
bracket.
To Next Page
Loading...
