CALL NOW 800.798.1779
www.infraredsauna.com
81
Using Your Sauna Control Panel
USING YOUR INFRARED SAUNA
Unlike a traditional sauna, infrared heats the body directly. Air temperature
in the sauna is not as important as the type and quality of the infrared being
received. We recommend the following protocol:
a. Turn the sauna on for 10 minutes to allow the heaters to come up to
optimal temperature and for the cabin to warm to a comfortable
temperature.
b. When you enter the sauna, set the time to the desired session time and
turn the thermostat up to 150+F / 65C. This will keep the heaters are on
the entire time to ensure that you are receiving constant
infrared heat. During a 30 minute sauna session, the air temperature
will reach between 115-125F / 46-51C depending on the starting
ambient air temperature.
c. Sit back and relax. Enjoy your sauna session.
When connected to the properly grounded power source, your Jacuzzi
®
sauna
will turn ON to the set temperature and count-down with
a few pushes of the Power button.
System On/Off
1) Press the “POWER” button once to
turn on the sauna.
2) Your session will automatically end
after the programmed timer expires.
3) ress the “POWER” button at any time
turn off the sauna.
Sauna Session Time
You can set the duration of your sauna
session for a maximum of 60 minutes.
Press the TIME UP or TIME DOWN buttons
to increase or decrease your desired sauna
session time in 5 minute increments.
When you have reached your desired time,
release the button.
Controlling the Set Temperature
You can program your sauna for a maximum temperature of 158°F (70°C). Press the TEMP UP/DOWN (+/-) buttons
to set the desired temperature. When the display shows your desired temperature, release the buttons. Press either
the TEMP UP or TEMP DOWN buttons during your sauna session to manually control the desired cabin temperature.
*See “Instructions For Use” on next page for recommendations.
To Next Page
Loading...
